High-performance ceramic coating from German company AHG Anschutz
Anschütz GunCoating is a high-performance ceramic coating for all types of firearms and knives.
Despite its excellent lubricity, Anschütz GunCoating leaves no residue, forms an invisible dry coating on the weapon and increases the sliding properties of moving weapon parts.
The hard, metallic sounds produced by rubbing parts - such as in repeating rifles - are significantly reduced.
Anschütz GunCoating forms a permanent bond to the surface, does not run off, and thus protects the weapon from corrosion in the long term.
Anschütz GunCoating can be used on all surfaces, such as steel, plastic, lacquered wood parts, gold and silver ornaments, color hardening, cast iron and rubber.
Anschütz GunCoating fills microscopic cracks and scratches and permanently smooths the treated surfaces. Wear is thus reduced to a minimum and the shooting performance of the gun is increased.
Anschütz GunCoating is effective from the first application - even on older guns!
Product characteristics:
- Suitable for knives and all types of firearms
- Can be applied to any surface
- Transparent, non-greasy coating without residue
- Very good sliding properties, long-lasting effect
- Resistant to salt and fresh water, economical to use
- High temperature resistance from -40 °C to +750 °C
- Non-resinous, non-sticky, colorless and odorless
- Facilitates the cleaning of weapons
Instructions for use:
Anschütz GunCoating is always applied to a cleaned gun. Metal parts should be degreased before application so that the ceramic particles can adhere directly to the metal. Anschütz GunCoating is applied in a thin layer to the surfaces and then spread with a dust-free cloth so that a thin, moist layer is applied to the surface. Anschütz GunCoating then dries automatically. The coating is dry at room temperature after about 30 minutes and fully cured after about 2 hours. When applying to the barrel, make sure that the barrel has been thoroughly cleaned beforehand. The aerosol is recommended for the care of large areas. The liquid product in a bottle with a dropper should be used for coating small parts and adjusting triggers.
Caution
Extremely flammable product. Pressurized container (aerosol can). May burst when heated. Protect from sunlight and do not expose to temperatures exceeding 50°C/122°F. Do not pierce or incinerate, even after use. Keep away from heat sources, hot surfaces, sparks, open flames and other sources of ignition. Do not smoke. Formation of explosive/highly flammable vapor/air mixtures possible during use.